Zhangjiagang City Nuoen machinery Co., LTD

+86-18036121234

CNC automatic pipe bending machine operation method

发布时间:2021-09-16 点击量:145

1, first turn on the power, turn on the switch on the control panel, and then start the oil pump, so that you can hear the sound of the oil pump rotation. (The machine does not move at this time)


2, stroke adjustment, use must pay attention to adjust the stroke, must be tested before bending. When the upper die goes down to the very bottom, there must be a gap of plate thickness. Otherwise it will cause damage to the mold machine. The adjustment of the stroke also has electric quick adjustment.


3, bending notch selection, generally to choose 8 times the width of the plate thickness of the notch. If bending 4mm sheet material, choose about 32 notches.


4, the rear stopper adjustment generally has electric rapid adjustment and manual fine-tuning, the method is the same as the shearing machine.


5, step on the foot switch began to bend, CNC bending machine mold and shearing machine is different, you can loosen at any time, loosen the foot will stop, continue to step down. Article source address: http://www.cn-wgj.com


上一条:暂无数据
Zhangjiagang City Nuoen machinery Co., LTD

Scan and follow us

+86-18036121234

Copyright ® Zhangjiagang City Nuoen machinery Co., LTD ALL Rights Reserveds.  ICP:  
Zhangjiagang City Nuoen machinery Co., LTD